DOEPFER A-100CGK Betriebsanweisung PDF herunterladen (Seite 3)

User's Guide page 3 DIY Synth Kit

Warranty

• All connections have to be carried out in the off-state of the DIY Synth kit (i.e. without

power supply)

• The DIY Synth kit is an electrostatic sensitive device. Avoid any electrostatic charges !

• Do not solder directly to any of the pin headers but use connectors to make the

connections between the DIY Synth kit and your application.

• Use only a power supply that corresponds to the specifications given in this manual (i.e.

+12V/GND/-12V).

• Applying a negative voltage less than –12V or a positive voltage beyond +12V at any of

the inputs may destroy the circuit.

• Avoid short cuts while DIY Synth kit is powered (e.g. caused by metallic or conducting

supports) !

• Ignoring any of these items will cause warranty loss !

• Return of the DIY Synth kit within the 2 weeks return time limit (valid only in Germany) is

only possible if all these items have been met. DIY Synth kit that have been soldered or

modified by the customer cannot be taken back.

Electronic knowledge is required to install and operate the DIY Synth kit. If you are not

sure whether your knowledge is sufficient please consult an expert. We cannot take

back kits that became defective because of wrong installation or wrong connection of

the controls or voltages. We also cannot take back modules or cables which have

been soldered by the user.

1 2 3 4 5 6 7 8 ... 23 24

Keine Kommentare

DOEPFER A-100CGK Betriebsanweisung Seite 3