DOEPFER A-100CGK Betriebsanweisung PDF herunterladen (Seite 2)

DIY Synth Kit Page 2 User's Guide

Important note

The DIY Synth kit is planned for experienced users only who are familiar with both

electronics and analog synthesizers. It is definitely unsuitable for beginners ! For

example we will not be able to offer the service to repair a customers assembly if it

does not work as it should, or to make individual suggestions how to wire the board

for special applications. We have to emphasize this fact very clearly in advance to

avoid unsatisfied customers who will have problems getting their synth to run.

If you are not sure if your skills are sufficient please return the DIY synth kit for money

refund before you start to wire the board !

Electrical safety / EMC compatibility

The DIY Synth kit is a so-called OEM product (OEM original equipment manufacturer) that

cannot be used independently but has to be combined with additional electrical or

electronical equipment to become a working device (suitable controls, switches, sockets,

power supply, case/housing and so on). The manufacturer of DIY Synth kit does not know

the final assembly of the complete device in which the DIY Synth kit is used as a part of the

complete device. The final responsibility with regard to electrical safety and

electromagnetic compatibility is up to the user who is assembling the complete device.

Please pay attention to the following items:

The power supply used in combination with the DIY Synth kit has to be a closed type. It is

not allowed to use open power supplies with open mains voltage access (e.g. via mains

lead, pcb tracks, electronic parts). For example the A-100 miniature power supply (A-

100MNT) can be used.

As no radiation is expected due to the 100% analog low frequency circuits no preventing

measures against electromagnetic radiation are met on the DIY Synth board. But it is

impossible to estimate to what extend the components added by the user affect the EMC

properties of the complete assembly (e.g. switching power supply). Therefore it is

recommended to shield the complete device against electromagnetic radiation (incoming and

outgoing). These demands are normally met by a closed metal case that covers the

complete assembly. The metal case should be connected to GND of the DIY Synth kit.

1 2 3 4 5 6 7 ... 23 24

Keine Kommentare

DOEPFER A-100CGK Betriebsanweisung Seite 2