Doepfer Pocket Electronic Bedienungsanleitung PDF herunterladen (Seite 10)

Page 10 Pocket Electronic User's Guide

Connector for snapshot button and LED (5)

PE has two simple controls available: a so-called snapshot button and a LED. If the user wants

to have available these controls they are connected to the pin header ST1 in this way:

The button is a simple momentary switch (open at rest) and any standard LED can be used (3

or 5 mm or rectangle, red/yellow/green/blue/white color). Pay attention to the polarity of the

LED. Normally the cathode (minus terminal) is indicated by a shortened pin and is the bigger

electrode inside the LED.

A 4 pin female connector can be used for wiring. This allows to disconnect the button and LED

from the electronics very easily.

The LED is essentially used as a control display, the button is used to send off all 16 Midi

messages with the data corresponding to the present positions of the 16 controls (snapshot

function). The functions of the snapshot button and the LED are described in detail in the

operation chapter of this manual.

DIP Switches (6)

The positions of the 8 switches of S2 determine the number of the preset that is called up during

power on. For details please refer to chapter "controls and operation".

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

Keine Kommentare

Doepfer Pocket Electronic Bedienungsanleitung Seite 10