Doepfer Pocket Electronic Bedienungsanleitung PDF herunterladen (Seite 11)

User's Guide Pocket Electronic Page 11

Mounting

Before PE is put into operation the board has to be fixed on a suitable support and built into a

metal case together with the controls (refer to EMC notes on page 2). The metal case has to be

connected to GND of PE. We recommend to use the metal plate of the voltage regulator

7805/IC6 or the GND terminal of the power supply socket for this connection.

The board measures about 80 x 56 x 25 mm. Five mounting holes with 3 mm diameter are

available for mounting the board inside the case e.g. with distance sleeves or spacers (> 5 mm

in length) and suitable screws. Pay attention that no short circuits are made – neither on the top

of the board (electronic parts) nor on the bottom (solder points or pcb tracks). In case of doubt

use isolating plastic parts (e.g. plastic screws, nuts and washers) for mounting.

Position of the mounting holes

(measures in mm)

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 31 32

Keine Kommentare

Doepfer Pocket Electronic Bedienungsanleitung Seite 11